Based on our close cooperation with leading high pressure pump manufacturers, we are in a position to offer you a wide spectrum of pressure generation aggregates for almost any application. That is your cost optimization guarantee, as the pressure generation is individually laid out for your application. The variations in this field range from pneumatically driven high-pressure generators with compact dimensions in pressure ranges between 10 and 550 MPa with corresponding pumping capacity, and hydraulically driven high-pressure generators that can supply up to 420 MPa operating pressure with an output of up to 10.2 l/min.



The most important part of a high-pressure aggregate is the pressure intensifier. Based on the area-ratio of the low-pressure piston to the high-pressure piston, a primary pending pressure is increased to a secondary operating pressure of up to 4200 bar. In a hydraulically driven pump, the primary pressure is always generated with an oil-hydraulic unit. The hydraulic unit can be omitted in pneumatically driven pumps as these pumps use compressed air as the primary motive power. That results in a cost benefit for compressed-air driven pumps and the makes portable use possible - an alternative for many cutting tasks.